Quantrex Quantrex AcademyJEE · NEET · NDA PYQs with solutions Open app
AP EAMCET201726 Apr 2017Morning ShiftPhysicsCommunication SystemActual

The process of recovering the modulating signal from the modulated carrier wave is called

Options

  1. Aamplification
  2. Bdetection
  3. Crectification
  4. Dnoise

Correct answer

B. detection

Step-by-step solution

After modulation, recovery of signal is done by demodulating it.

Practice Communication System on Quantrex Academy →

More from Communication System

In amplitude modulation, if a message signal of 5 kHz is modulated by a carrier wave of frequency 900 kHz, then the frequencies of the side bands are 2025The heights of tansmitting and receiving antennas are respectively 1 20000 and 1 80000 times the radius of the earth. The maximum distance between these two antennas for satisfacto 2025The layer of the atmosphere that reflects low frequency (LF) electromagnetic waves during day time only is 2025If the ratio of the maximum and minimum amplitudes of an amplitude modulated wave is 7: 3 , then the modulation index is 2025If the maximum and minimum amplitudes of a modulated wave are 25 V and 5 V respectively, then the modulation index is 2025Ionosphere acts as a reflector for the frequency range of 2025If in an amplitude modulated wave, the maximum amplitude is 14 V and the modulation index is 0.4, then the amplitude of the carrier wave is 2025For transmitting a signal of frequency 1000 kHz, the minimum length of the antenna is 2025 Full Communication System list All AP EAMCET PYQs