Quantrex Quantrex AcademyJEE · NEET · NDA PYQs with solutions Open app
NTA Abhyas JEE Main2020PhysicsSemiconductorsPractice

A working transistor with its three legs marked P , Q and R is tested using a multimeter. No conduction is found between P and Q . By connecting the common (negative) terminal of the multimeter to R and the other (positive) terminal to P or Q , some resistance is seen on the multimeter. Which of the following is true for the transistor?

Options

  1. AIt is an n-p-n transistor with R as base
  2. BIt is an p-n-p transistor with R as collector
  3. CIt is an p-n-p transistor with R as emitter
  4. DIt is an n-p-n transistor with R as collector

Correct answer

A. It is an n-p-n transistor with R as base

Step-by-step solution

Since no conduction is found when the multimeter is connected across P and Q it means either both P and Q are n-type or p-type. So, it means R is base. When R is connected to the common terminal and conduction is seen when another terminal is connected to P and Q, so it means transistor is in n-p-n configuration with R as the base.

Practice Semiconductors on Quantrex Academy →

More from Semiconductors

The output Y for the given inputs A and B to the circuit is: 2026Refer to the logic circuit given below. For two inputs (A=1, B=1) and (A=0, B=1) , output (Y) will be __________. 2026The maximum rated power of the LED is 2 mW and it is used in the circuit with input voltage of 5 V as shown in the figure below. The current through resistance R_S is 0.5 mA. The m 2026In a semiconductor p-n diode, the doping concentrations on p-side and n-side are 10¹⁵ atoms/cm ^3 and 10¹⁸ atoms/cm ^3 , respectively. Which one of the following statements is true 2026For the given logic circuit, which of the following inputs combination will make both LED -1 and LED -2 to glow? 2026Given below are two statements: one is labelled as Assertion A and the other is labelled as Reason R Assertion A: A diode under reverse-biased condition provides very small current 2026A diode has Zener voltage of 10 V and maximum power dissipation of 0.5 W, then the minimum resistance to be used in series with this diode for safety when it is connected to a 25 V 2026Two 4 bits binary numbers, A = 1101 and B = 1010 are given in the inputs of a logic circuit shown in figure below. The output (Y) will be: 2026 Full Semiconductors list All NTA Abhyas JEE Main PYQs