Quantrex Quantrex AcademyJEE · NEET · NDA PYQs with solutions Open app
AIIMS2019PhysicsMechanical Properties of Solids

Identify the incorrect statement.

Options

  1. AYoung's modulus and shear modulus are relevant only for solids.
  2. BBulk modulus is relevant for solids, liquids and gases.
  3. CAlloys have larger values of Young's modulus than metals.
  4. DMetals have large values of Young's modulus than elastomers.

Correct answer

C. Alloys have larger values of Young's modulus than metals.

Step-by-step solution

Metals have larger values of Young's modulus than alloys and elastomers.

Practice Mechanical Properties of Solids on Quantrex Academy →

More from Mechanical Properties of Solids

Match List I with List II : List I List II A. Young's Modulus I. d L ( L d ) B. Compressibility II. F L A( L) C. Bulk Modulus III. - 1 P ( V V ) D. Poisson's Ratio IV. -P ( V V ) C 2026A metallic bar of Young's modulus, 0.5 10¹¹ ~N ~m ⁻² and coefficient of linear thermal expansion 10⁻⁵ ^ C ⁻¹ , length 1 m and area of cross-section 10⁻³ ~m ^2 is heated from 0^ C t 2024The maximum elongation of a steel wire of 1 m length if the elastic limit of steel and its Young's modulus, respectively, are 8 10^8 ~N ~m ⁻² and 2 10¹¹ ~N ~m ⁻² , is: 2024Let a wire be suspended from the ceiling (rigid support) and stretched by a weight W attached at its free end. The longitudinal stress at any point of cross-sectional area A   2023The amount of elastic potential energy per unit volume (in SI unit) of a steel wire of length 100 ~cm to stretch it by 1 ~mm is (if Young's modulus of the wire =2.0 10¹¹ ~N ~m ⁻² ) 2023Given below are two statements : One is labelled as Assertion (A) and the other is labelled as Reason (R). Assertion (A): The stretching of a spring is determined by the shear modu 2022A wire of length L , area of cross section A is hanging from a fixed support. The length of the wire changes to L 1 when mass M is suspended from its free end. The expression for Y 2020Two wire of same material having radius in ratio 2: 1 and lengths in ratio 1: 2 . If same force is applied on them, then ratio of their change in length will be 2019 Full Mechanical Properties of Solids list All AIIMS PYQs