Quantrex Quantrex AcademyJEE · NEET · NDA PYQs with solutions Open app
99 Percentile Qs Bank for JEE MainPhysicsExperimental Physics

The main scale of a vernier calliper reads in mm and its vernier scale is divided into 8 divisions, which coincides with 7 divisions of the main scale. It was also observed that, when the two jaws are brought in contact, the zero of the vernier scale coincided with the zero of the main scale. The edge length of a cube is measured using this vernier calliper. The main scale reads 12 mm and the 2 nd division of the ver

Correct answer

1225

Step-by-step solution

8 VSD = 7 MSD ⇒ 1 VSD = 7 8 MSD LC = 1 MSD - 1 VSD LC = 1 MSD - 7 8 MSD = 1 8 MSD = 1 8 mm l = 12 + 2 × 1 8 = 12 . 25 mm

Practice Experimental Physics on Quantrex Academy →

More from Experimental Physics

Two thin wires, Wire-1 of diameter 0.650 mm and Wire-2 of unknown diameter d are given. To obtain the value of d , the diameters of the two wires are measured with a screw gauge. T 2026In a Vernier calipers, when both jaws touch each other, zero of the Vernier scale is shifted to the right of zero of the main scale and 7^ th Vernier division coincides with a main 2026In a screw gauge when the circular scale is given five complete rotations it moves linearly by 2.5 mm. If the circular scale has 100 divisions, the least count of screw gauge is __ 2026In a screw gauge the zero of main scale reference line coincides with the fifth division of the circular scale when two studs are in contact. There are 100 divisions in circular sc 2026In an experiment, a set of reading are obtained as follows - 1.24 ~mm , 1.25 ~mm , 1.23 ~mm , 1.21 mm. The expected least count of the instrument used in recording these readings i 2026When both jaws of vernier callipers touch each other, zero mark of the vernier scale is right to zero mark of main scale, 4^ th mark on vernier scale coincides with certain mark on 2026In a vernier callipers, 50 vernier scale divisions are equal to 48 main scale divisions. If one main scale division =0.05 ~mm , then the least count of the vernier callipers is _ _ 2026In a screw gauge, the zero of the circular scale lies 3 divisions above the horizontal pitch line when their metallic studs are brought in contact. Using this instrument thickness 2026 Full Experimental Physics list All 99 Percentile Qs Bank for JEE Main PYQs